E-ZZ-NNAILCLIP? T EST TERMINALS
For use with breadboard circuits, exPerimental hookuPs and harness board connections, to Pretest circuits, modules,
comPonents and burn-in boards.
Use E-Z-NailcliP test terminals to hold wire ends firmly in Place for a quick, sure connection. Smooth, tough hook holds
wire ends firmly against the nylon slide without cutting, nicking, or damaging lead wires. E-Z-NailcliPs drive into wood
like a nail using the T-20 Tool, or can be Pressed into Predrilled holes. Products can easily be soldered below board and
simPle finger tiP oPeration saves in construction time by sPeeding wire Placement. The rectangular hole design in the slide
eliminates hook rotation. NailcliPs are available with a variety of factory-installed adaPters.
Colors: Available in 10 colors.
STANDARD TEST TERMINAL
Construction:
One-Piece nickel silver shaft and
hook. Durable heat and chemical
resistant nylon slide. Stainless steel
comPression coil sPring. Requires T-
20 tool to drive into wood or PE-93
Perf-eze adaPter to Press into
standard Perf board holes.
Colors: Available in 10 colors.
Part No. DescriPtion
81-11 Standard Hook
ALL M ETAL T EST T ERMINAL F OR
HIGH TEMPERATURE U SE
Construction:
One-Piece nickel silver shaft and
hook. Durable heat and chemical
resistant nylon slide. Stainless steel
comPression coil sPring. Requires T-
20 tool to drive into wood or PE-93
Perf-eze adaPter to Press into
standard Perf board holes.
Part No. DescriPtion
84-11 High TemPerature Hook
MULTIPLE WIRE TEST TERMINAL
Construction:
One-Piece nickel silver shaft and
hook. Durable heat and chemical
resistant nylon slide. Stainless steel
comPression coil sPring. Requires T-
20 tool to drive into wood or PE-93
Perf-eze adaPter to Press into
standard Perf board holes.
Colors: Available in 10 colors.
Part No. DescriPtion
83-88 Hook for MultiPle Wires
HEAVY DUTY TEST TERMINAL
Construction: Three-level coPPer,
nickel and tin Plated temPered
steel hook. Nylon slide. Stainless
steel sPring.
Colors: Available in 10 colors.
Part No. DescriPtion
86-11 Heavy Duty Hook
INSULATION-PPIERCING W IRE C LAMP
Mounting Board
Minimum hold
sPacing for high
density grouPing.
Materials a nd F inish
Housing:
Lever:
Contact Bolt:
SPrings:
Steel; coPPer, nickel, & tin-Plated
Nylon molded in ten different colors
Brass nickel Plated
Stainless steel
No need to striP wire end for continuity testing.
Wires can be installed from three different
sides. If more than one wire is to be held in the
same clamP, use the same wire AWG and insert
Part No.
82-22
DescriPtion
Insulation-Piercing Wire ClamP
from the front only, and to the same dePth.
Max. Jaw OPening
www.e-zz-hho o k.coom
68
相关PDF资料
1050XR-36 MINI HOOK XR CABLE 36"
1055512-1 TORQUE WRENCH 9/32" SMA
1068.1012.1110001 KEYPAD PIEZO 3X4 12KEY ALUMINUM
1068.1016.1112001 KEYPAD PIEZO AL 16KEY BLOCK
1081-60-2 CORD MINI BANA PLUG PATCH 60"RED
10910 HARDWARE DECORATIVE NUT 1/4-40
10PA2 SEAL BOOT FOR LIMIT SWITCH
10PA4 TOGGLE SWITCH SEALING BOOT
相关代理商/技术参数
1050XR-36 功能描述:MINI HOOK XR CABLE 36" RoHS:是 类别:测试设备 >> 测试引线 - 香蕉,量表接口 系列:E-Z-MINI-HOOK™ XR 标准包装:1 系列:6570 类型:插接线 配置:香蕉插头至短头鳄鱼夹 第一连接器:香蕉插头,单,屏蔽,直角 第二连接器:接线夹,隔离型,特大号 线缆长度:60.0"(1524.00mm) 所含物品:1 根引线,红 材料 - 绝缘体:硅树脂 堆叠方法:不可堆叠 线规:18 AWG 电压 - 额定:1000V(1kV) 额定电流:20A 额定值:CAT III 1000V,IEC 1010
1051 功能描述:电池座、电池扣和电池接头 THM BATTERY HOLDER CR123A RoHS:否 制造商:Eagle Plastic Devices 产品:Battery Snaps 电池组电池大小:9 V 电池数量:1 端接类型:Snaps 颜色:Black 材料:Polyvinyl Chloride (PVC) 安装风格:Snap-In
1051 制造商:TIME ELECTRONICS 功能描述:RESISTANCE BOX LOW OHM 制造商:TIME ELECTRONICS 功能描述:RESISTANCE BOX, LOW OHM
105-1/2 制造商:Thomas & Betts 功能描述:
10510 功能描述:LED 照明镜头 Optic 10mm RoHS:否 制造商:Ledil 类型:Lenses 用于:Osram Oslon SSL 直径:9.9 mm 显示角:36 deg 封装:Bulk
10-510 制造商:Datak Corporation 功能描述:Nuts Hex Hex 3/8in Nylon 10-32 制造商:Thomas & Betts 功能描述:CRIMPSLEEVE CONNTRS
105-1000 功能描述:光谱分析仪 SCOPE ADAPTER RoHS:否 制造商:B&K Precision 频率范围:
105-1001-001 制造商:Johnson Components 功能描述:ELECT. CIRCUIT HARDWARE - Bulk 制造商:Emerson Connectivity Solutions 功能描述:Conn Tip Jack F 1 POS ST Panel Mount 1 Port 制造商:EMERSON NETWORK POWER 功能描述:Conn Tip Jack F 1 POS ST Panel Mount 1 Port